Advanced Coatings and Beyond

Website: http://www.advancedcoatingsandbeyond.com

PRODUCT NAME: WP 1819

PRODUCT NUMBER: 213WP1, 213WP5, 213WP55

PRODUCT APPLICATION: Elastomeric Coating for Concrete, Stucco and Walls.

Apply over clean surface. Remove any debris or chemical that will interfere with adhesion. All surfaces must be fully cured. Do not apply below 40 degrees F. Apply when there is no threat of rain , dew, or frost. Refer to MSDS for additional health and safety precautions.

Product Description

WP 1819 is a fluid applied elastomeric specialty coating. This high solids content, elastomeric coating was developed with long term performance in mind. WP1819 is a breathable which allows moisture to escape. Uniform in color and resist discoloration due to exposure to sunlight and weathering. It is a great wall coating product for interior and exterior applications and is available in flat or gloss. It may be applied with a brush, roller or sprayed. Standard colors available. Color matching is available. (fees apply for color matching)

Advantages

WP 1819 provides an ultra long lasting, maintenance free, flexible coating. This coating is designed to provide a waterproof, continuous, seamless, durable, weather resistant membrane. Use WP 1819 with our SurCure Primer for superior adhesion and longevity. WP 1819 is a breathable membrane which allows moisture to escape. It is uniform in color and resists discoloration due to exposure sunlight and weathering. WP 1819 is available in standard colors, and color matching is available (charges apply).

Packaging and Mixing

It is recommended that this product NOT be reduced with water before use.  Shake or stir liquid thoroughly before use. WP 1819 is packaged ready to use and may be applied with a brush, roller or spray.

Coverage

Approximate 75 sq ft per gallon. When applied at the recommended rate.*

Available in the following container sizes:

1 Gallon 213WP1

5 Gallon 213WP5

55 Gallon 213WP55

Note: 250 Gallon Totes (213WP250T) are available with special ordering.

*Rates will vary depending upon type, porosity, and condition of substrate.

Technical Properties

Appearance: FLAT/GLOSS White

Dry film thickness: 8 to 12 mil.

Dry time: @ 70 F and 50% RH: to touch 30 minutes -to recoat 2 hours

Volume Solids:  10 mil = 51.4%

Weight Solids: 10 mil = 62.0%

Weight Gallons: 10 mil = 11 lbs

Flash Point - 201F closed gap

Elongation: 10 MIL = 300%

Tensile Strength: 10 mil = 288%psi

Safety and Health: Refer to the MSDS for additional health and safety precautions.